Carbon Monoxide (CO) Gas Detection and Heater Control System with PPM Level at LCD in Vechile

Carbon Monoxide (CO) Gas Detection and Heater Control System with PPM Level at LCD in Vechile
Product Code: NRD_PROJ_0603
Availability: 5
Qty:        

In this project we are going to provide an advanced solution for detect PPM level of carbon monoxide gas in vehicle. As per use of heater use increasing day by day in the vehicles. It is very important to control level of carbon monoxide but when a high level CO occurs then it may produce heavy disaster. We are using MQ-7 gas sensor which provide maximum resistance at leakage time. When CO gas sensor detected it produce a buzzer sound also it switch on the exhaust fan and Switch off Heater system. We can set this at different PPM level of CO gas.

The onboard CO Sensor (MQ-7) provides the CO contents in the air. If this found above set PPM value then it will inform the Host controller by pulling the Digital Output Pin to High and onboard status LED glow. The sensor module is mainly intended to provide a means of comparing CO sources and being able to set an alarm limit when the source becomes excessive.

**For any clarification & help you can directly contact our designer at 8130113106

OR Visit us : www.nrdcentre.com

  • Project Synopsis Download

http://www.nrdcentre.com/image/data/Gas Sensor/CO Detection.pdf

 

  • Project Report and other doc will send through email.

 

  • Datasheet of MQ-7 CO Gas Sensor

http://www.nrdcentre.com/image/data/Gas Sensor/MQ7.pdf

Write a review

Your Name:


Your Review: Note: HTML is not translated!

Rating:            Good

Enter the code in the box below:



Copyright © 2013 Naksh Researcher & Designer Centre
Please Share